Corgi Underfloor Heating Cables (1 to 8.4 Square Metre Coverage available)

NWT2020-38723
Corgi Underfloor Heating Cables
search
  • Corgi Underfloor Heating Cables

CORGI heating cables are perfect for providing luxurious underfloor heating beneath virtually any floor surface and are particularly well suited to installation in larger rooms. The cables can be installed directly beneath a tiled floor or almost any other floor covering if covered with a levelling compound first.

Choose Size:
Thermostat:
£61.00
VAT included
local_shipping If you order before 2pm your order will be delivered FREE on Friday, 22nd November

Data sheet

Colour Family
Red
Brand
Corgi Corgi

CORGI heating cables are perfect for providing luxurious underfloor heating beneath virtually any floor surface and are particularly well suited to installation in larger rooms. The cables can be installed directly beneath a tiled floor or almost any other floor covering if covered with a levelling compound first. If your room is a high heat loss/poorly insulated area such as a conservatory we recommend installing the cable at 200W per sqm. If your room meets current building regulations 150W per sqm should provide full room heating.


All heating cables must be connected in parallel not in series. Make sure you never cut, shorten, lengthen, strain or cross heating cables. You must always ensure the floor sensor is not fitted near another heat source such as a radiator pipe or where rugs, mats or furniture are expected to be placed on top of the floor. Start laying the cable at a point close to the thermostat to make the connection simple. Continue to lay your heating cable at the desired spacing taking care not to place any cable closer than 30mm to conductive parts or other heating cables.


  • Easy to install
  • Perfect for use under tiles, carpets, vinyl and laminate floors
  • The floor base must be firm, level, and free of dust, dirt and oil
  • Constructed with a 3mm cable – extremely low build height
  • Dual conductor/single cold tail
  • All heating cables must be connected in parallel not in series!
  • IP Rating: IPX7 (as required by the 17th Edition)
  • Fully 17th Edition and Part L compliant
  • Cable: Length 23.5m
  • Ohms Value +/- 10%: 140 Ω
  • Approved to: EN 60335-1:1998, EN 60335-2-17:1999, IEC 60730

Some of our other product ranges.
Fireclay Sinks Pull Out Basket Strainer Waste without Overflow 90mm - Chrome
doneIn Stock

£37.00
Add to cart
800mm Bath End Panel - Midnight Blue
doneIn Stock

£97.00
Add to cart
Ravi Mono Basin Single Lever Round Basin Tap & Rinser - Chrome
doneIn Stock

£153.00
Add to cart
Satin Green 1700mm Two Piece Front Bath Panel & Plinth
doneIn Stock

£166.00
Add to cart

cookie